My circuit breaker cable stopped working. What should I do?

Try this for your circuit breaker cable:

  1. Back out the screw that holds the switch plug in place and remove the plug. You will then see a small hole in the outer jacket of the cable.
  2. With wire cutters or a sharp blade, cut off an inch or so of cable, just below that hole.
  3. Gently insert the freshly cut cable into the plugs using a circular motion. Make sure the cable is inside the plug as far as it can go.
  4. Finally, tighten down the screws gently to make contact with the center conductor.

If this does not work for some reason, please contact us.

Was this article helpful?
0 out of 0 found this helpful